Get a quote

Battery Charging Time Calculator

Enter the battery's capacity, how charged it is now and your charger's output in amps. The meter estimates how long it takes to reach full and whether the charger is the right size for the battery.

AE-hAuto-range · 12/24 V
Time to full–

Not sure of the charge? Measure the rested voltage and use the battery test: 12.24 V is about 50%.

Charge to put back
–
Main charge
–
Top-off
–
Charger size
–

Lead-acid batteries need about 15% more charge than they gave out, and the last 20% goes in slowly as the charger reduces current. Lithium charges at almost full current to about 95%.

The simple answer, capacity divided by charger amps, underestimates charging time for lead-acid batteries. Some energy is lost as heat, and a smart charger reduces its current once the battery reaches about 80% to avoid gassing, so the last fifth of the charge can take as long as the first four-fifths. This calculator models both stages.

Choosing the right charger size

BatteryGood charger sizeExample: 100 Ah
Standard / EFB car battery10–20% of Ah10–20 A
AGM10–30% of Ah10–30 A
Gel10–20% of Ah10–20 A
Lithium (LiFePO4)20–50% of Ah20–50 A
Maintainer / trickle chargerUnder 5% of Ah1–4 A, for storage

A 4–8 A smart charger suits most car batteries. For deep cycle and dual battery setups, a 15–25 A charger recovers the battery in an evening. See battery chargers for types and prices.

Charging stages on a smart charger

  • Bulk: full current until the battery reaches about 14.4 V (lead-acid) or 14.2–14.6 V (lithium). Most of the charge goes in here.
  • Absorption: voltage held steady while the current tapers. For lead-acid this takes 2–4 hours.
  • Float or maintenance: a lower voltage, about 13.5 V, keeps a lead-acid battery full indefinitely. Lithium chargers usually switch off instead.

Driving doesn't fully recharge a flat battery: 30 minutes of town driving replaces only a small part of a deep discharge, and a smart alternator may never top it off. After a flat battery, charge it fully with a charger, then check the cause with the Parasitic Battery Drain Calculator or the Battery and Alternator Test Calculator.

From a reading to a quote

These tools help you understand the problem and ask the right questions, but they don't replace a proper test. An auto electrician checks the vehicle with the right equipment and confirms the cause before replacing parts. When you are ready, send what you found in the quote form, with Battery Chargers and Jump Starters already selected, and an auto electrician or supplier in your area will contact you with a price.

Frequently asked questions

How long does it take to charge a car battery?
A 60 Ah car battery at half charge takes about 6–8 hours on a 6 A smart charger, including the slow top-off. A completely flat battery on the same charger takes 12 hours or more.
Can I charge a car battery too fast?
Yes. High current heats a lead-acid battery and makes it gas, which loses water and damages the plates. Keep charging current at about 10–20% of the battery's Ah rating, or use a smart charger that limits it.
Can I leave a battery charger connected?
A smart charger with a float or maintenance mode can stay connected for weeks. An old manual charger without regulation will overcharge and damage the battery if left on.

More auto electrical tools

Get a free quote