Every modern vehicle draws a little current with the ignition off to keep the clock, radio presets, alarm and control-module memories alive. That drain is normally 20–50 mA, which a healthy battery can supply for weeks. A faulty module, a light that doesn't switch off or a badly wired accessory can draw ten times that and flatten a battery in two or three days.
How to measure parasitic drain
- Make sure the battery is charged. Switch everything off, remove the key and close the doors. Leave the bonnet open with the latch closed by hand (push a screwdriver into the latch) so the car thinks it is shut.
- Set a multimeter to its 10 A DC range. Disconnect the negative battery terminal and connect the meter in series between the negative post and the cable.
- Wait 20–45 minutes for the control modules to go to sleep. The reading drops in steps as they do. Switch to the mA range for an accurate reading once it is below about 200 mA.
- Don't open a door, press the remote or crank the engine with the meter connected: the surge can blow the meter's fuse.
To find the circuit, measure the millivolt drop across each fuse in the fuse box without removing them. A fuse with a voltage across it is carrying current. Pulling fuses one by one also works, but can wake the modules and restart the wait.
Common causes of battery drain
- Lights: boot, glovebox, bonnet or vanity mirror lights whose switches have failed.
- Aftermarket accessories: alarms, trackers, dash cams in parking mode, and radios wired to a permanent feed instead of the ignition.
- Stuck relays: fuel pump, radiator fan or aircon relays that stay closed.
- Modules that won't sleep: body control modules, infotainment units and keyless entry systems, often after water damage or a software fault.
- Charging faults: a failed diode in the alternator can leak current to earth. If the drain disappears when you unplug the alternator's main cable, the alternator is the cause.
From a reading to a quote
These tools help you understand the problem and ask the right questions, but they don't replace a proper test. An auto electrician checks the vehicle with the right equipment and confirms the cause before replacing parts. When you are ready, send what you found in the quote form, with Car Battery Replacement already selected, and an auto electrician or supplier in your area will contact you with a price.
Frequently asked questions
What is a normal parasitic drain on a car battery?
How long can a car sit before the battery dies?
Will a tracker or alarm drain my battery?
More auto electrical tools
- LIGHTSDashboard Warning Lights GuideWhat each warning light means, how urgent it is and whether you can keep driving. Filter by colour.
- V DCBattery and Alternator Test CalculatorEnter resting, cranking and running voltages from a multimeter to see if the battery, starter or alternator is at fault.
- mm²12V / 24V Wire Size and Voltage Drop CalculatorThe cable size you need for a load, run length and voltage, and the voltage you lose along the way.
- AFuse and Relay Size CalculatorTurn watts into amps, pick the right fuse rating and blade fuse colour, and see whether you need a relay.
- AhDual Battery and Fridge Battery CalculatorSize an auxiliary battery for a fridge, lights and charging, and check whether your DC-DC charger and solar keep up.
- hBattery Charging Time CalculatorHow long a charger takes to fill a car, deep cycle or lithium battery, and whether the charger is the right size.